Items Supplied; Safety Instructions - EINHELL RT-SP 260 Originalbetriebsanleitung

Anleitung_RT_SP_260_260_D_SPK1__ 19.07.12 11:19 Seite 20
GB
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.
1. Layout
1 On/Off switch
2 Selector switch for planing/thicknessing
3 Push stick
4 Hand crank
5 Sawdust extractor
6 Parallel stop
7 Clamping lever
8 Mounting for planing knife cover
9 Setting knob for the chip depth
10 Lever selector
11 Transport handles
12 Planing knife cover
13 Infeed table
14 Planing table
15 Ratchet lever
16 Ratchet lever
17 Locking lever for table
18 Transportation wheels
19 Feet
20 Door
21 Knife
22 Latch
23 Knife block
24 Anti-kick claws
25 Switch/plug unit
26 Allen key
27 Wrench
28 Sawdust extractor hood
29 Pin
30 Spacer roller
31 Table guide
32 Parallel stop guide
33 Scale
34 Base panels
35 Side panels
36 Side panels
37 Back panels
38 Cross strut
39 Stop rule
40 Scale
20
41 Pointer
42 Thicknessing table
43 Plastic spring
44 Feeding roller
45 Belt cover
46 Belt

2. Items supplied

Plane
n
Base frame
n
Assembly tool
n
Push stick
n

3. Safety Instructions

Please refer to the booklet included in delivery for
the safety instructions.
4. Important information
Always switch off the On/Off switch (1) and pull
n
the mains plug out of the socket before carrying
out any maintenance work or having the machine
serviced. (Fig. 1)
Check at regular intervals that the knife (21) and
n
latch (22) are firmly attached in the knife block
(23). (Fig. 36)
The knives (21) must not project more than a
n
maximum of 1.1 mm out of the knife block (23).
(Fig. 45)
Never remove the safety covers on the machine
n
except for servicing and repair work.
The safety covers must be intact at all times. Each
n
time you use the machine, first fasten and secure
the safety covers at the points provided.
Connect a dust extractor to the sawdust extractor
n
(5) if you use the machine in an enclosed area.
(Fig. 1)
Please note: The machine must be safely
n
earthed. The yellow/green connector wire is the
protective conductor.
Make sure that the anti-kick claws (24) work
n
correctly. (Fig. 5)
Always wear eye protection.
n
Never cut concavities, tenons or shapes.
n
This machine will provide the performance
described in these operating instructions if it is
correctly assembled, used, maintained and
repaired. The machine must be inspected at
regular intervals. Never use any defective parts,