Intended Use; Noise Emission Values - EINHELL RT-SP 260 Originalbetriebsanleitung

Anleitung_RT_SP_260_260_D_SPK1__ 19.07.12 11:19 Seite 21
including power cables. Damaged, missing, worn
and deformed parts must be replaced immediately.
Only qualified personnel are permitted to carry out
repairs or replace parts. No modifications may be
made to the machine or any machine parts if these
would result in the machine differing from the
standard specifications.

5. Intended use

The surfacing and thicknessing plane is designed
for the surfacing and thicknessing of all types of
whole pieces of square, rectangular or chamfered
converted timber.
The machine is to be used only for its
prescribed purpose.
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. There is a risk of the following injuries in
connection with the required operation of the
machine.
Fingers or hands coming into contact with the
n
knife block in areas which are out of view.
Workpieces may kick back if the machine is used
n
incorrectly.
Damage to hearing and eye injuries plus injuries
n
to fingers and hands if the required protective
equipment is not used.
Harmful emissions when used in enclosed areas
n
without a suitable extractor system.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

6. Noise emission values

Sound and vibration values were measured in
accordance with EN 61029.
RT-SP 260D/260
Sound pressure level L
pA
K uncertainty
pA
Sound power level L
WA
K uncertainty
WA
The quoted values are emission values and not
necessarily reliable workplace values. Although
there is a correlation between emission and
immission levels it is impossible to draw any certain
conclusions as to the need for additional
precautions. Factors with a potential influence on the
actual immission level at the workplace include the
duration of impact, the type of room, and other
sources of noise etc., e.g. the number of machines
and other neighboring operations. Reliable
workplace values may also vary from country to
country. With this information the user should at least
be able to make a better assessment of the dangers
and risks involved.
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Keep the noise emissions and vibrations to a
minimum.
n
n
n
n
n
n
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
2. Damage to hearing if no suitable ear protection is
7. Technical data of the RT-SP 260 D
AC motor:
Power P:
Power P:
Protection type:
Vibration a
Operation Idle speed
Max. workpiece width:
94.8 dB(A) 80.7 dB(A)
Max. workpiece height at thickness opening: 160 mm
3 dB
Infeed table:
104.8 dB(A) 91.1 dB(A)
Planing table:
3 dB
Thicknessing table:
Thicknessing feeding speed:
Idle speed of motor n
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
is used.
used.
:
w
:
0
GB
400V 3 ~ 50 Hz
1900 W S1
2800 W S6 40%
IP40
12 m/s²
260 mm
500 x 282 mm
500 x 282 mm
400 x 260 mm
5 m/min
2800 rpm
21