Further Safety Instructions - Parkside PDOS 200 C2 Originalbetriebsanleitung

c) Remove the plug from the wall
socket and/or remove the re-
chargeable battery before you
change the device's settings,
change accessory parts or put
away the power tool. Such pre-
ventive safety measures reduce the risk
of starting the power tool accidentaIly.
d) Store idle power tools out of the
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
e) Look after the power tool and
application tool carefully. Check
for misalignment or binding
of moving parts, breakage of
parts and any other condition
that may affect the power tool's
operation. If damaged, have the
power tool repaired before use.
Many accidents are caused by poorly
maintained power tools.
f) Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
g) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking
into account the working condi-
tions and the work to be per-
formed. Use of the power tool for op-
erations different from those intended
could result in a hazardous situation.
h) Keep handles and grip surfaces
dry, clean and free from oil and
grease. Slippery handles and grip
surfaces do not permit safe operation
and control over the power tool in un-
expected situations.
GB
5) SERVICE
a) Have your power tool serviced
by a qualifi ed repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
Safety information for bench
grinders
a) Never use damaged attach-
ment tools. Check attachment
tools such as grinding discs for
chipping or cracks before each
use. If you have checked the
attachment tool and attached it,
keep yourself and any nearby
persons out of the plane of the
rotating attachment tool and al-
low the device to run for 1 min.
at the highest rotational speed.
Damaged attachment tools usually
break during this test period.
b) The permissible rotation speed
of the attachment tool must be
at least as high as the highest
rotation speed indicated on the
attachment tool. Accessories that
run faster than the allowable speed
can break and fl y apart.
c) Never grind using the side sur-
faces of the grinding discs. Grin-
ding using the side surfaces can cause
the grinding disc to burst and fl y apart.

Further Safety Instructions

• Connect the device only to a power
point with a residual current protective
device (RCD) with a measured residual
current of not more than 30 mA.
• Keep the mains cable and extension
cable away from the grinding disc. In
IE NI CY
9