Finish Operation - Kärcher SP 6 Flat Inox Bedienungsanleitung

NOTICE
The higher the level sensor is adjusted, the higher the
switch-on and switch-off point.
See the following table for application examples:
Min / Max
Shaft with a diame-
ter < of approx.
1 m (e.g. drainage)
Float basin, pond
(only SP 7 Flat In-
ox) or something
similar
 Set the switch to automatic mode (AUTO).
 Insert the mains plug into the socket.
Manual operation
NOTICE
In manual operation the pump remains switched on
continuously.
Illustration
 Set the switch to manual operation (MAN).
 Insert the mains plug into the socket.
ATTENTION
Risk of damage! Dry running leads to increased wear;
never leave the pump unattended during manual oper-
ation. Unplug immediately in case of dry running
12
SP 6 Flat Inox SP 7 Dirt Inox
Level sensor in Level sensor in
the upmost po- the upmost posi-
sition tion
It is recom- Pre-filter flaps
mended to use closed (protec-
the pre-filter. tion against soil-
ing)
Level sensor in Level sensor in
the lowest posi- the lowest posi-
tion tion
Start pumping Pre-filter flaps
operations with closed (protec-
pre-filter or tion against soil-
folded out sup- ing)
port legs
Continuation -
pumping oper-
ations without
pre-filter and
folded in sup-
port legs (resid-
ual fluid height
1 mm is
reached)
Note
Perform in
manual mode.
Check the
switch-off/shal-
low suction.
Flat vacuuming (SP 6 Flat Inox)
It is recommended to use manual mode to reach the
min. residual fluid height of 1 mm.
A check valve is installed for the SP 6 Flat Inox. This
prevents residual fluid in the hose from flowing back af-
ter the pumping process finishes.

Finish operation

NOTICE
Soiling can deposit and lead to malfunctions.
 Pump clear water or thoroughly rinse the pump af-
ter every use.
This especially applies after pumping chlorinated
water or other liquids that leave residue.
 Disconnect the main plug from the socket.
The pump is maintenace-free.
CAUTION
In order to prevent accidents or injuries, keep in mind
the weight of the appliance during transport (see Spec-
ifications).
 Lift and carry the pump on the carrying handle.
 If you want to transport the appliance on a vehicle
secure it from slipping.
CAUTION
In order to prevent accidents or injuries, keep in mind
the weight of the appliance when selecting a storage lo-
cation for it (see Specifications).
 Completely drain the pump and allow it to dry.
 Store the pump in a frost-free place.
– 3
EN
Maintenance
Transport
Storage
Storing the pump