Finish Operation - Kärcher GP 50 M 4 Betriebsanleitung

Start up
Please follow the safety instructions before
start-up!
Description of the Appliance
1 Power cord with plug
2 Aluminium carrying handle
3 Connection G1(33.3mm) Pressure pipe
4 Cover and prefilter
5 Filling nozzle
6 Connection G1(33.3mm) Suction pipe
7 Connection G1" (33.3 mm) on G1" (33.3
mm)
8 Cover flap
9 Handle
10 ON/OFF switch
11 Foot for vertical storage
Preparing the Appliance
Transport the appliance to the location
site by its aluminium carrying handle.
Illustration
Connect suction and pressure pipes us-
ing Kärcher special accessory
G1"(33.3mm).
The appliance can be operated via both
lateral pressure connections. If only one
pressure line is used, the protective cap
must be screwed onto the unused con-
nection.
Illustration
Unscrew the lid of the filling nozzle and
fill in water till it overflows.
Screw on the lid on the filling nozzle.
Note: If sandy water is to be transported,
we strongly recommend using an additional
prefilter (see special accessories). Please
install this filter on the suction side of the
pump, between the suction hose and the
pump.
16 English
Operation
Caution
The pump may only be operating while it is
lying down!
Note:Before each use, you need to ensure
that the device is connected according to
the description in the chapter on Prepara-
tions because programs saved can start im-
mediately as soon as you plug in the mains
plug.
Insert the mains plug into the socket.
Illustration
Tip: lift the pressure hose to approx. 1 mm
to shorten the suction time
Turn the appliance on via the on/off
switch.
Wait till the pump sucks in and trans-
ports water uniformly
The unit is now ready for use.
Caution
If there is a lack of water supply or an ex-
tended interruption of the water removal,
the water will heat up in the pump head
while the pump is running!
The pump may be operated for maximum 3
minutes in this operating status.
If the pump is operated in this condition for
an extended period of time, the metal cas-
ing of the pump
will heat up and there will be a risk of scald-
ing!
For these cases, the pump is equipped with
an overheat protection, which will switch
the pump off.

Finish operation

Rinse the pump after every use if you
use to transport water with additives.
Turn off the appliance.
Disconnect the main plug from the sock-
et.
7
Deutsch