Kärcher SP 6 Flat Inox Bedienungsanleitung Seite 10

Please read and comply with these origi-
nal operating instructions and the en-
closed safety instructions. Proceed ac-
cordingly. Keep both booklets for future reference or
subsequent owners.
Contents
Warranty
Environmental protection
Description of the Appliance
Proper use
Approved feed fluids . . . . . . . .
Start up
Operation
General . . . . . . . . . . . . . . . . . .
Automatic venting device . . . . .
Automatic operation . . . . . . . . .
Manual operation . . . . . . . . . . .
Flat vacuuming (SP 6 Flat Inox)
Finish operation
Maintenance
Transport
Storage
Storing the pump . . . . . . . . . . .
Special accessories
Troubleshooting
Specifications
The warranty terms published by the relevant sales
company are applicable in each country. We will repair
potential failures of your appliance within the warranty
period free of charge, provided that such failure is
caused by faulty material or defects in manufacturing. In
the event of a warranty claim please contact your dealer
or the nearest authorized Customer Service centre.
Please submit the proof of purchase.
The adhesive type label must not be removed from the
device. Warranty is no longer granted if the label is re-
moved.
Environmental protection
The packaging material can be recycled.
Please do not place the packaging into the or-
dinary refuse for disposal, but arrange for the
proper recycling.
Old appliances contain valuable materials that
can be recycled. Please arrange for the proper
recycling of old appliances. Please dispose
your old appliances using appropriate collec-
tion systems.
Note
The oil used to seal the ceramic slide ring is biodegrad-
able. No negative effects are expected for humans or
the environment if the oil smears or leaks.
Notes about the ingredients (REACH)
You will find current information about the ingredients
at:
www.kaercher.com/REACH
10
Contents
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Warranty
Description of the Appliance
1 Switch (automatic mode / manual operation)
2 Carrying handle
3 Power cord with plug
4 Rail (level sensor)
5 Level sensor
6 Automatic venting device
1
7 Quick-Connect
1
8 Pump connecting piece (1", 1¼" and 1½" hose con-
1
nection and G1½ - thread)
1
9 Check valve (SP 6 Flat Inox)
1
10 Connection nozzle (G1½ - thread)
1
11 Pre-filter (SP 6 Flat Inox removable)
2 12 Support legs (SP 6 Flat Inox)
2
2
This appliance has been designed for use in private
2
households and is not intended for commercial use.
2
The manufacturer is not responsible for any damages
3
that may occur on account of improper use or wrong op-
3
erations.
3
The device is mainly intended for draining building parts
3 in case of flooding, but also for pumping over or out con-
tainers, for water removal from wells and shafts as well
3
as for draining water from boats and yachts, provided
3
that it is fresh water.
3
NOTICE
4
The device is not suitable for continuous pump opera-
4
tion (e.g. continuous circulation in a pond) or as a sta-
5
tionary installations (e.g. lifting device, fountain pump).
Approved feed fluids
 Fresh water up to a certain degree of soiling
Water from swimming pool (provided the dosing of

additives is proper)
 Washing lye, e.g. leaked washing machine load.
Then clean with clear water.
Sp 7 Dirt Inox (wastewater pump)
 Water with a degree of contamination up to a grain
size of 30 mm
SP 6 Flat Inox (clean water pump)
 Water with a impurities up to a maximum grain size
of 5mm
DANGER
Risk of injury, risk of damage! Caustic, slightly inflam-
mable and other explosive substances (such as petrol,
petroleum, diluted nitrogen), greases, oils, salt water
and waste water from toilets as well as sludgy water that
has a slower flow capacity than water, must not be
transported with this pump. The temperature of the de-
livered fluid must be between 5 °C and 35 °C.
– 1
EN
Proper use