A) Installation In The Radio Slot - Renkforce RUSD-SP Bedienungsanleitung

a) Installation in the Radio Slot
• Unlock the installation frame with the two unlocking keys (figure 1, item 1).
• Remove the installation frame towards the back of the system (figure 1, item 2).
• Insert the frame into the respective cut-out in the vehicle (figure 2).
• Bend down some clips in the installation frame until the frame is securely fastened in the recess
(figure 3).
• When you have made all the electrical contacts (see „Electric Connection") insert the car radio into the
frame until it locks in (figure 4).
Keep the two unlocking keys. You will need them for a later removal of the car radio.
• Protect your car radio from vibrations with the bolt at the back of the unit.
• In most vehicles, such a safety fastening is provided for. If this is not the case in your car, fasten the car
radio with the enclosed punched metal strip.
For the fastening, proceed as shown in the following figure:
3