Receiver - StarTech.com IES101002SFP Bedienungsanleitung

Syntax:
sFlow Configuration

26.2 Receiver

sFlow>Receiver ?
Description:
Set or show the sFlow receiver timeout, IP address, and UDP port.
Syntax:
sFlow Receiver [release] [<timeout>] [<ip_addr_host>] [<udp_port>] [<datagram_size>]
Parameters:
release Release the current owner of the receiver.
The owner can either be "<none>" if the receiver is not currently owned
by anyone, it can be "<Configured through local management>" if it's
currently set up by CLI or Web, or it can be anything else if is set-up
through SNMP.
You can only (re-)configure the receiver if it is not currently owned by
anyone or owned by CLI or Web.
If this argument is specified, the remaining arguments are ignored.
<timeout> Receiver timeout measured in seconds. The switch
decrements the timeout once per second, and as long as
it is non-zero, the receiver receives samples. Once the
timeout reaches 0, the receiver and all its configuration
is reset to defaults.
Valid range is 0 - 2147483647 seconds.
<ip_addr_host> IPv4/IPv6 address or a hostname identifying the receiver.
<udp_port> Receiver's UDP port. Valid range is 0 - 65535.
Use 0 to get default port (which is 6343).
<datagram_size> Maximum datagram size. Valid range is 200 - 1468 bytes.
Default is 1400 bytes.
Instruction Manual
269