Storm Broadcast; Qcl Add - StarTech.com IES101002SFP Bedienungsanleitung

Parameters:
enable
disable
<packet_rate>

17.35 Storm Broadcast

QoS>Storm Broadcast ?
Description:
Set or show the broadcast storm rate limiter.
The limiter will only affect flooded frames,
i.e. frames with a (VLAN ID, DMAC) pair not present in the MAC Address table.
Syntax:
QoS Storm Broadcast [enable|disable] [<packet_rate>]
Parameters:
enable : Enable broadcast storm control
disable : Disable broadcast storm control
<packet_rate>: Rate in fps (1, 2, 4, ..., 512, 1k, 2k, 4k, ..., 1024k)

17.36 QCL Add

QoS>QCL Add ?
Description:
Add or modify QoS Control Entry (QCE).
If the QCE ID parameter <qce_id> is specified and an entry with this QCE ID
already exists, the QCE will be modified. Otherwise, a new QCE will be added.
If the QCE ID is not specified, the next available QCE ID will be used. If
the next QCE ID parameter <qce_id_next> is specified, the QCE will be placed
Instruction Manual
215
Enable multicast storm control
Disable multicast storm control
Rate in fps (1, 2, 4, ..., 512, 1k, 2k, 4k, ..., 1024k)