Commissioning; Connection; Licensing With Esi[Tronic] Startcenter; Esi[Tronic] Startcenter Installation - Bosch KTS 340 Betriebsanleitung

en 22 | ��S ��� | Commissioning
4.

Commissioning

�.1

Connection

Prior to commissioning, make sure the mains voltage
coincides with the voltage specified on the power
supply unit (use the power cord provided).
i
The German power cord is included in the scope
of delivery.
�.2 Licensing with
ESI[tronic] Startcenter
Before the KTS 340 can be used for control unit diag-
nosis, the "ESI[tronic] Startcenter software must be in-
stalled on a PC/Laptop and the KTS 340 then licensed.
!
Do not connect the KTS 340 to the PC/Laptop until
prompted to do so during the installation routine.
�.2.1

ESI[tronic] Startcenter installation

Procedure:
1. Insert the " ESI[tronic] Startcenter" DVD in the DVD
drive (e. g. "D:\") of the PC/Laptop.
2. Open the " Execute" input box (select "Start >>
Execute..." in the task bar).
D:\setup.exe
3. Enter
?
Set-up is started.
4. Select the installation language and confirm with
<O�>.
i
The same language as that selected for installation
will also be used in the ESI[tronic] Startcenter.
5. Follow the installation instructions on the screen.
i
The country in which the KTS 340 is to be used must
be chosen in the "Country selection" installation
menu.
|
1 689 989 038 2008-08-15
and confirm with <O�>.
!
The Windows operating system USB driver instal-
lation routine is not to be implemented when the
KTS 340 is first connected to the PC/Laptop. The
ESI[tronic] Startcenter installation routine automati-
cally installs the USB driver to permit communication
between the KTS 340 and the PC/Laptop.
i
If there is no Adobe Reader on the PC/Laptop, this
software will be installed at the end of the ESI[tronic]
Startcenter installation routine. An Adobe Reader is
required to display the KTS 340 control unit diagnosis
protocols on the PC/Laptop.
6. Re-start the computer on completion of installation.
?
Windows is shut down and the ESI[tronic] Start-
center re-started.
7. Perform KTS 340 licensing by fax or online.
i
The Online Help is opened up in the "
menu. This contains all the essential information on
the ESI[tronic] Startcenter.
Help >> Help"
Robert Bosch GmbH