Wlan; Current Measurement (Ch1 And Ch2); Continuity Tester (Ch1); Diode Measurement (Ch1) - Bosch KTS 340 Betriebsanleitung

en �� | ��S ��� | �echnical data
7.�.�

Current measurement (CH1 and CH2)

Sensor
Shunt (CH1 only)
30 A clip (CH1 only)
100 A clip
600 A clip
1000 A clip (CH1 only)
7.�.5

Continuity tester (CH1)

Properties Value/range
Measurement current 2 mA
No-load voltage ≤ 5 V
< 10  (with acoustic signalling)
Continuity
7.�.6

Diode measurement (CH1)

Properties Value/range
Measurement current 2 mA
No-load voltage ≤ 5 V
Maximum diode voltage 2 V
|
1 689 989 038 2008-08-15
Measuring range
±600 mA
±30 A
±100 A
±600 A
±1000 A
7.5

WLAN

Standard: IEEE 802.11g (54 Mbit/s), compatible with
IEEE 802.11b (11 Mbit/s), data encoding: WPA,
WPA-PSK, WPA2, WPA2-PSK, WEP (64/128/256 bits),
antenna: -3dBi.
Radio link
��S ��� to PC/Laptop
Free field workshop environment
In passenger compartment, with vehicle
door or window open and engine
running
The range of the WLAN differs considerably.
20–40 m can normally be achieved indoors and up to
100 m outdoors.
Under adverse conditions the effective range may only
be 10–15 m or even less.
The KTS 340 automatically adapts the transmission
rate in the WLAN to the transmission conditions. In the
event of a poor radio link the data are transmitted
more slowly than with a good link.
7.5.1 MPE Statement (Maximum Permissible expo-
sure)
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with mini-
mum distance 20 cm between the radiator & your body.
7.5.2 §15B Statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the condition that this device
does not cause harmful interference.
Minimum range
30 meters
10 meters
Robert Bosch GmbH