General Safety Directions For Power Tools - FLORABEST FHT 600 E3 Originalbetriebsanleitung

Machines are not to be place with
domestic waste.
Safety class II (Double insulation)
Cutting length
General Safety Directions for
Power Tools
WARNING! Read all safety
directions and instructions.
Omissions in the compliance with
safety directions and instructions
can cause electrical shock, fire
and/or severe injuries.
Retain all safety directions and in-
structions for future use.
The term „power tool" in the warnings refers
to your mains-operated (corded) power tool
or battery-operated (cordless) power tool.
Work area safety
Keep work area clean and well
•
lit. Cluttered or dark areas invite ac-
cidents.
Do not operate power tools in
•
explosive atmospheres, such as
in the presence of flammable
Iiquids, gases or dust. Power tools
create sparks which may ignite the
dust or fumes.
Keep children and bystanders
•
away while operating a power
tool. Distractions can cause you to
lose control.
Electrical safety
CAUTION! The following states
how to avoid accidents and injuries
due to electric shock:
Power tool plugs must match
•
the outlet. Never modify the
plug in any way. Do not use
any adapter plugs with earthed
(grounded) power tools. Unmodi-
fied plugs and matching outlets will
reduce risk of electric shock
Avoid body contact with
•
earthed or grounded surfaces,
such as pipes, radiators, ranges
and refrigerators. There is an in-
creased risk of electric shock if your
body is earthed or grounded.
Do not expose power tools to
•
rain or wet conditions. Water
entering a power tool will increase the
risk of electric shock.
Do not abuse the cord. Never
•
use the cord for carrying, pulling
or unplugging the power tool.
Keep cord away from heat, oil,
sharp edges or moving parts.
Damaged or entangled cords increase
the risk of electric shock.
When operating a power tool
•
outdoors, use an extension cord
suitable for outdoor use. Use of a
cord suitable for outdoor use reduces
the risk of electric shock.
If operating a power tool in a
•
damp location is unavoidable,
use a residual current device
(RCD) protected supply. Use of an
RCD reduces the risk of electric shock.
• If the replacement of the supply
cord is necessary, this has to be
done by the manufacturer or his
agent in order to avoid a safety
hazard.
Personal safety
CAUTION: In this way you avoid
accidents and injuries:
GB IE NI
7