Control Elements - Donauer High Efficiency 3.0 Bedienungsanleitung

7.3.3

Control elements

The control elements shown on the display, which are used for performing settings in the inverter,
are described below using illustrative examples.
Selection list with check boxes
2 2
2 2
2 2
Selection list with radio buttons
2 2
2 2
2 2
Dialogs (general)
Numerical settings
2 2
742.641 | 11.43
 Designation of the selection list
1
 Check boxes with names:
3
 Scroll bar
 Designation of the selection list
1
 Radio buttons with names:
3
 Scroll bar
 Dialog heading
1
 A question presented to the user
 Response possibilities:
2 2
Confirm (answer the question with Yes): press and hold
3
 Designation of the numerical setting
1
 Value to be set; the selected value to be set is highlighted
2 2 2 2
When performing numerical settings of remuneration and
dates, the following applies:
Remuneration
• Possible currencies: £ (pound), € (euro), kr (krone), none
• The maximum value that can be set for remuneration is
Date
When setting the month/year, a check is performed to ensure
that the selected day is valid. If not, then the day is automati-
cally corrected.
Example: 31.02.2011 is corrected to 28.02.2011.
Check boxes allow multiple selection
–
The currently selected check box is highlighted in black
–
Preset check boxes have no frame and are always
–
switched on (cannot be changed)
Radio buttons are exclusive-OR (only one radio button
–
can be switched on)
The currently selected radio button is highlighted in
–
black
Back (cancel): press ESC
SET for 1 second
in black
limited for technical reasons. If necessary, the remunera-
tion must be set using different units. Example: dollars
instead of cents (set a currency of none).
EN
47