Scheppach PLB52BP Originalbetriebsanleitung Seite 33

Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the front
page.
ATTENTION
Important note in the case of repairs
When returning the product for repair, for safety rea-
sons, ensure that it is free of oil and fuel when it is sent
to the service centre.
14.1 Ordering spare parts
Please provide the following information when ordering
spare parts:
• Model designation
• Item number
• Type plate data
16 Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your product failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
The product cannot be started
The product starts up and then im-
mediately shuts down.
Engine runs unsteadily
Smoke is produced
Product does not work at full power
15 Disposal and recycling
Notes for packaging
You can find out how to dispose of the disused
device from your local authority or city
administration.
Fuels and oils
Possible cause
Air filter dirty.
Missing fuel supply.
Fault in the fuel line.
Contaminated spark plug that is too wet
due to excess fuel.
Spark plug connector not plugged in.
No ignition spark.
Engine defective.
Carburettor defective.
Incorrect carburettor setting
(idle speed).
Incorrect carburettor setting.
Air filter dirty
Spark plug dirty
Incorrect fuel mixture.
Incorrect carburettor setting.
Air filter dirty.
Spark plug dirty
Incorrect carburettor setting.
www.scheppach.com
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
• Before disposing of the product, the fuel tank and the
engine oil tank must be emptied!
• Fuel and engine oil do not belong in household waste
or drains, but must be collected or disposed of sepa-
rately!
• Empty oil and fuel tanks must be disposed of in an en-
vironmentally friendly manner.
Remedy
Clean/replace the air filter.
Check that there is sufficient fuel in the
tank and refuel if necessary.
Check the fuel line for kinks or damage.
Remove spark plug, clean and dry; then
pull the starter cable several times; rein-
sert the spark plug.
Check that the spark plug connector is
properly seated.
Check that the spark plug connector is
properly seated.
Check the spark plug for dirt and the cor-
rect electrode gap.
Check ignition cable for damage.
Contact the service point.
Contact the service point.
Contact the service point.
Setting the idling speed
Contact the service point.
Setting the idling speed
Contact the service point.
Clean or replace the air filter.
Clean or replace the spark plug.
Use two-stroke mixture with the mixing
ratio of 40:1.
Contact the service point.
Clean or replace the air filter.
Clean or replace the spark plug.
Contact the service point.
GB | 33