Connection Diagram; Special Accessories - Bosch KTS 560 Originalbetriebsanleitung

en | 20 | KTS 560 / 590 (KTS 5a Series) | Device description
BLUETOOTH Function
LED
Off No data communication via Bluetooth.
Flashing Data communication via Bluetooth.
green
DIAGNOS- Function
TICS
LED
Off No data communication with control unit.
Green light Data communication with control unit.
"Recovery mode" key
i
The "Recovery Mode" key is only used to perform
a firmware update of KTS 560 / 590 in the case of
malfunctions.
After the "Recovery Mode" key is pressed > 3 seconds,
the ERROR LED lights up red and the firmware can be
updated via DDC (Diagnostic Device Configuration). Af-
ter a firmware update, the ERROR LED must extinguish.
If the firmware is not updated after the "Recovery
mode" key is pressed, the voltage supply and the USB
connecting cable must be disconnected. After the volt-
age supply is reconnected, the ERROR LED must be off
again.
3.5

Special accessories

Information on optional accessories, such as vehi-
cle-specific connection cables, extra measurement ca-
bles and connection cables can be obtained from your
Bosch authorized dealer.
3.6 Operation
The KTS 560 / 590 can be connected to a PC/laptop
by way of a radio link (Bluetooth) or the USB interface.
For a radio link, the Bluetooth USB adapter has to be
plugged into the PC/laptop.
i
The radio link between the KTS 560 / 590 and the
PC/laptop can only be established using the Blue-
tooth USB adapter included in the scope of delivery.
i
The Bluetooth USB adapter supplied is not required
for a DCU 100 / 130 / 220 with internal Bluetooth
hardware.
|
1 689 989 223 2016-07-20
3.6.1

Connection diagram

9
8
7
6
Fig. 6: Connection diagram for the KTS 590 as example
1 OBD interface in motor vehicle
2 OBD connection cable
3 Measurement cables
4 Measurement cables (KTS 590)
5 Power supply unit
6 KTS 590
7 USB connection cable
8 Bluetooth USB adapter for USB 3.0
9 PC (Laptop)
1 2
3
4
5
Robert Bosch GmbH