Steelcase Flex Collection HAD Bedienungsanleitung Seite 39

Change displayed height unit – CM / INCH
control panel. The unit can be changed via the menu (menu
F 1).
1. Press the "Steelcase" button for six seconds and
then release the button.
=
F 1 is displayed.
2. Press the "Steelcase" button again.
3. Now press the "Up" button for inches or
4. Press the "Down" button for cm.
5. Press the "Steelcase" button to confirm the
selection.
The submenu is exited if the "Steelcase" button is not
pressed after 10 seconds.
ü If the display was previously set to centimetres
(cm), it will now be switched over to inches (inch)
and vice versa.
Calibration of the height display
If the displayed height does not correspond to the actual
height of the desktop, the display can be corrected as follows
(menu F 2).
1. Press the "Steelcase" button for six seconds and
then release the button.
=
F 1 is displayed.
2. Press the "Up" or "Down" button until F 2 is shown
on the display.
3. Press the "Steelcase" button to confirm.
=
The display and the edge lighting start to flash.
4. Measure the current desk height and correct the
height currently shown on the display to the
measured height with the "Up" or "Down" button.
5 Operating and adjusting
EN
39