Steelcase Flex Collection HAD Bedienungsanleitung Seite 40

5 Operating and adjusting
Calibration of the height display
The submenu is exited if the "Steelcase" button is not
pressed after 10 seconds.
Limit height adjustability - set
These settings can limit the desktop movement range (e.g. if
there is a rolling file cabinet under the desk or a set of shelves
above it). The stopping positions for the rolling file cabinet
become the new lowermost end position, and the shelf
stopping positions become the new uppermost end position
(F 4 menu).
EN
Limit height adjustability - delete
To delete the movement range limitation of the desktop,
proceed as follows (menu F 5).
40
5. Press the "Steelcase" button to confirm.
ü The correct height of the desk is now displayed.
1. Move the desktop to the lower half or the upper half
of the movement range.
2. Press and hold the "Steelcase" button for 6
seconds.
=
F 1 is displayed.
3. Press the "Up" or "Down" button until F 4 is shown
on the display.
=
A display appears with one bar at the top left and
one at the bottom right.
}
Press the "Up" button to save the upper end
position or
}
Press the "Down" button to save the lower end
position.
4. Press the "Steelcase" button to confirm.