Steelcase Flex Collection HAD Bedienungsanleitung Seite 30

5 Operating and adjusting
5 Operating and adjusting
5.1 Safety instructions
The Flex Collection HAD may only be used and operated in
perfect technical condition and in compliance with the user
guide.
Before first use and subsequent use after reassembly, ensure
the following:
EN
30
■
The desk has been properly assembled and the table
legs are securely locked (bracket closed and secured
by the motor cable housing).
■
The motor cables of the control box are connected to
the control panel and table legs.
■
The desktop must be level. If the desktop is not level,
first check whether the floor is even. If the floor is
uneven, adjust the height using the adjusting screws
on the feet. If the desktop is still not level, you must
perform a manual reset of the desktop.
−
Controller Simple Up/Down (PUI01) on
page 33
−
Controller Programmable with Display (PUI02)
on page 35
−
Controller Up/Down with Display (PUI03) on
page 41
−
Paddle Up/Down with LED (PUI04) on page 46
■
No persons or objects (e.g. open doors or windows)
must be in the lifting range or protrude into the lifting
range.
■
No persons must be on or sitting at the desk.
■
The maximum permissible desk load-carrying
capacity is not exceeded.