Hitachi RC-BGH1FA0G Bedienungsanleitung Seite 9

Cool Mode
Use the device for cooling when the outdoor temperature is -10 to 46°C.
If humidity is very high (over 80%) indoors, some dew may form on the air outlet grille of the indoor
unit.
Press the Mode Selector Button so that the display indicates
(Cool).
Set the desired Fan Speed with the
display indicates the setting).
( Auto
(Super High)
Set the desired room temperature with the Temperature Buttons (the
display indicates the setting).
The temperature setting and the actual room temperature may vary
depending on conditions.
Temperature range can be set between 16.0°C and 32.0°C.
Press the (On/Off) button. Cooling operation starts with a
beep. Press the button again to stop operation. The cooling function
does not start if the temperature setting is higher than the current
START
room temperature (even though the
STOP
cooling function will start as soon as you set the temperature below
the current room temperature.
As the settings are stored in the memory of the remote controller, you
only have to press the
During Auto fan, the fan speed automatically changes as below:
● W hen the difference between room temperature and setting
temperature is large, fan starts to run at Super High speed.
● A fter room temperature reaches the preset temperature, fan speed
will be changed to lower speed to obtain optimum room temperature
condition for natural healthy cooling.
- 9 -
(Fan Speed) button (the
) (Silent)
(Operation) lamp lights). The
(On/Off) button next time.
(Low)
(Medium)