Hitachi RC-BGH1FA0G Bedienungsanleitung Seite 3

Preparation Before Operation
NOTE
Note on setting the calendar and clock.
● If the Calendar and clock are not set, the On Timer, Off Timer, My Mode with timer, LH days and Weekly
Timer cannot be set.
● If the Calendar and clock are not set correctly, the On Timer, Off Timer, My Mode with timer, LH days and
Weekly Timer will not operate correctly.
● When the On Timer, Off Timer, My Mode, LH days, and Weekly Timer are set, the Calendar and clock
cannot be changed. If there is a need to change the Calendar and clock, On Timer, Off Timer, My Mode, LH
days, and Weekly Timer need to be cancelled.
● During calendar and clock setting change/update, if no key press for 60 seconds or any active key press,
then it will come out of clock setting and shows the previous set value.
● If calendar and clock is not set, then "Year" & "--" stop blinking after 60 seconds if no further steps
performed but user can set calendar and clock at any time by following steps mentioned above or if user
press any timer functions related keys (A/B, On Timer, Off Timer, Time Up/Down).
To set calendar and clock
1. Press (Reset) button when first time setting.
"Year" blinks.
2. Press (Time) button to set the current year.
3. Press (Clock) button. "Day" and "Month" blink.
4. Press (Time) button to set the current day and month.
5. Press (Clock) button. "
6. Press (Time) button to set the clock to the current
time.
7. Press (Clock) button.
Calendar and clock are set.
To modify the calendar and clock, press
button.
Then follow steps 2 to 7.
Calendar and clock need to be set again after changing the
batteries or when remote controller reset.
After changing the batteries,
1. Press (Reset) button.
2. Direct remote controller towards indoor unit and press
(Info) button.
3. The calendar and clock from indoor unit will be
transmitted.
■ Calendar and clock will not be transmitted from indoor
unit when the following occurs:
● When there is a power failure.
● When breaker is OFF by user (unit is not in
STANDBY MODE).
● When indoor unit does not have Date and clock
information.
● When remote controller does not received signal
from indoor unit
- 3 -
" blinks.
(Clock)