Hitachi RC-BGH1FA0G Bedienungsanleitung Seite 7

Heat Mode
● U se the device for heating when the outdoor temperature is under 24°C.
When it is too warm (over 24°C), the heating function may not work in order to protect the device.
Defrosting
Defrosting will be performed about once an hour when frost forms on the heat exchanger of the
outdoor unit, for 5~10 minutes each time.
During defrosting operation, the operation lamp blinks in cycle of 2 seconds on and 1 second off.
The maximum time for defrosting is 20 minutes.
However, if the indoor unit is connected to multi type outdoor unit, the maximum time for defrosting
is 15 minutes.
(If the piping length used is longer than usual, frost will likely to form.)
Press the Mode Selector Button so that the display indicates
(Heat).
Set the desired Fan Speed with the
display indicates the setting).
Auto
( )
(Super High)
Set the desired room temperature with the Temperature buttons (the
display indicates the setting).
The temperature setting and the actual room temperature may vary
depending on conditions.
Temperature range can be set between 16.0°C and 32.0°C.
START Press the (On/Off) button. Heating operation starts with a
STOP
beep. Press the button again to stop operation.
As the settings are stored in the memory of the remote controller, you only
have to press the
During Auto fan, the fan speed automatically changes as below:
● W hen the difference between room temperature and setting temperature
is large, fan starts to run at Super High speed.
● A fter room temperature reaches the preset temperature, fan speed will be
changed to lower speed to obtain optimum room temperature condition
for natural healthy heating.
- 7 -
(Fan Speed) button (the
(Silent)
(On/Off) button next time.
(Low)
(Medium)