Hitachi RC-BGH1FA0G Bedienungsanleitung Seite 28

Initialisation of the Built-in airCloud Go Module
●
Y ou can reset the internal settings (restore the factory settings) by remote controller.
How to restore factory setting
Please make this setting with the remote control in off mode.
OK
● P ress button (Mode) and
3 seconds together.
● L CD will display "
3 seconds then it will display normal screen.
● M ake sure " " Lamp on the indoor unit flash 4 times
repeatedly for about 20 seconds.
● R estart the unit & check "
ensures that unit enters into pairing mode & restoring factory
setting is succeeded.
NOTE
• Please note that the configuration will be cleared and pairing procedure
will be required to do again to use the built-in airCloud Go module.
• Please refer separate operation manual available for more information
related Built-in airCloud Go Module.
"Wi-Fi" is a trademark or registered trademark of the "Wi-Fi Alliance".
- 28 -
button (On Timer)
" on Temperature segment for
" Lamp blinks 3 times. This