Hitachi RC-BGH1FA0G Bedienungsanleitung Seite 4

Names and Functions of Remote Controller
REMOTE CONTROLLER
● This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor lighting is
controlled electronically, the range of control may be shorter.
This unit can be fixed on a wall using the fixture provided. Before fixing it, make sure the indoor unit can be
controlled from the remote controller.
● Handle the remote controller with care. Dropping it or getting it wet may compromise its signal transmission
capability.
● After new batteries are inserted into the remote controller, the unit will initially require approximately 3~4
seconds to respond to commands and operate.
● When remote controller is not in use for about 3 minutes during OFF condition, indicated by
display, the LCD will turn off.
● During clock setting, the LCD will turn off about 3 minutes later if the remote controller is not in use.
● When pressing any button, the LCD will turn on.
● The LCD will not turn off during TIMER setting.
Off Mode Sign
Room Temperature Sensor
A temperature sensor inside the
remote controller senses ambient
temperature around the remote
controller.
Mode Selector Button
Use this button to select the
operation mode. Every time you
press this button the mode will
change from (Heat)
(Cool) (Dry)
(Fan) cyclically.
( Page 6)
SleepSense Button
( Page 23)
Smart Eco Button
Use this button to set the Eco
mode.
( Page 20)
Temperature Button
Room temperature setting.
Value will change quicker when
keep pressing.
( Page 6)
Signal Transmission(transmitting)/Receiving
(Auto)
- 4 -
on the
Invalid Operation Sign
Shown at invalid setting or
operation
Transmission Sign
The transmission sign blinks
when a signal has been sent.
On/Off Button
Press this button to start
operation.
Press it again to stop
operation.
( Page 6)
Fan Speed Button
Select the fan speed.
( Page 6)
Powerful Button
( Page 10)
Silent Button
( Page 25)