Hitachi RC-BGH1FA0G Bedienungsanleitung Seite 17

Mould Guard Function (fan only) (For multi model connection)
●
A fter the cooling operation is stopped, the fan of the indoor unit is dried by fan mode to suppress the
generation of Mould inside the indoor unit.
- Mould Guard Operation period is about 60 minutes.
- It can't remove Mould or sterilize.
Cooling or Dehumidify
operation
Running
● " " Lamp on the indoor unit lights up during
● I f the air conditioner is operated in cooling or drying mode, for more than 10 minutes and then put
into off mode, the Mould Guard operation will start.
● Room temperature or humidity may rise.
NOTE
• If unit operation is stopped after heating operation, Mould Guard will not operate.
• If operation of Unit is stopped by Off Timer , the Mould Guard will not operate.
• If On Timer is set and on time is within about 2 hours, the Mould Guard will not operate.
• Room temperature or humidity may rise during Mould Guard operation.
• When there would be the window near indoor unit, the water might condense on the window during
Mould Guard. If necessary, to cancel Mould Guard.
The Process of Mould Guard
More than 10 min.
Mould Guard
The upper and lower deflector(s) remain open
Stop
Mould Guard
How to set and cancel Mould Guard
For setting
P ress the room temperature Up button

1
for 3 seconds together while remote controller in OFF mode with
directing remote control towards indoor unit.
" " is displayed on the LCD.
For cancelling
 P ress the room temperature Up button
for 3 seconds together while remote controller in OFF mode with
directing remote control towards indoor unit.
2
" " is disappear on the LCD.

O nce Mould Guard function set, Mould Guard icon will always display

on the LCD. And it stored in the memory of remote controller and remain
set even after reset or battery replacement case. It is one time setting
procedure to use this function.
How to stop at middle point of Mould Guard operation
 Press the button (On/Off) twice, the operation will stop.
3
 " " Lamp on the indoor unit turns off. But setting for Mould Guard
will not cancel, it will stop operation only.
- 17 -
About 60 min.
operation.
and On Timer
and On Timer
button
button