Remaining Hazards - Scheppach 590 6102 901 Originalanleitung

ated by persons familiar with it and instructed in its
operation and procedures.
• Arbitrary alterations to the machine release the manu-
facturer from all responsibility for any resulting dam-
ages.
• The machine may only be used with original accesso-
ries and original tools supplied by the manufacturer.
Any other use exceeds authorization. The manufacturer
is not responsible for any damages resulting from un-
authorized use; risk is the sole responsibility of the
operator.
m Remaining hazards
The machine has been built using modern technology in ac-
cordance with recognized safety rules. Some remaining haz-
ards, however, may still exist.
• Noise can be a health hazard. If the permitted noise
level is exceeded when working, be sure to wear ear
protection.
• The use of incorrect or damaged mains cables can lead
to injuries caused by electricity.
• Even when all safety measures are taken, some remain-
ing hazards which are not yet evident may still exist.
• Remaining hazards can be minimized by following the
instructions given in the chapters „Safety notes" and
„Use as authorized" as well as in the entire operating
manual.
Even when all safety measures are taken, it is not possible
to exclude all remaining hazards. Due to the construction
of the machine, the following risks can occur:
• Injury of the lung when no breathing mask is worn.
• Injury of the ear when no ear protection is worn.
• Injury of the eyes when no efficient goggles (or protec-
tive screen) are worn.
Warning:
If an air hose is broken off or damaged, the air input on
the compressor must be switched off. A broken air hose
that is not supported, is extremely dangerous and can
quickly start to rotate, hitting people or blowing foreign
bodies in the air.
Do not try to catch the hose. Instead, immediately remove
all spectators from the dangerous area, cut off the air in-
put, and switch the machine off by pressing the ON/OFF
switch. Then remove the hose from the compressor.
unpacking
Due to modern series production it is improbable that
your compressor has any defects or that a part is miss-
ing. Should you note a fault, however, do not switch the
machine on before the parts are replaced or the fault has
been remedied. Not observing this instruction can lead to
serious injuries.
international 19