Bauknecht BCS7P8PHTSK Bedienungsanleitung Seite 24

Please note: Once a function has been selected, the display
will recommend the most suitable level for each function. At
any time you can stop the function that has been activated
by pressing .
If the oven is hot and the function requires a specific
maximum temperature, a message will shown on the
display. You can either select a different function or
wait for a complete cooling.
6. PREHEATING
Some functions have an oven preheating phase: Once
the function has started, the display indicates that the
preheating phase has been activated.
Once this phase has finished, an audible signal will
sound and the display will indicate that the oven
has reached the set temperature, requiring to "ADD
FOOD". At this point, open the door, place the food in
the oven, close the door.
Please note: Placing the food in the oven before preheating
has finished may have an adverse effect on the final cooking
result. Opening the door during the preheating phase will
stop pause it.
The cooking time does not include a preheating
phase. You can always change the temperature you
want the oven to reach using
7. TURN OR CHECK FOOD
Some Dynamic functions will require the food to be
turned during cooking.
TURN FOOD
An audible signal will sound and the display shows
the action to be done. Open the door, do the action
prompted by the display and close the door.
In the same way, at 10% of time before the end of
cooking, the oven prompts you to check the food.
CHECK ON FOOD
An audible signal will sound and the display shows
the action to be done. Check the food, close the door.
Please note: Press to skip these actions. Otherwise, if no
action is done after a certain time the oven will continue the
cooking.
8. END OF COOKING
An audible signal will sound and the display will
indicate that cooking is complete.
END
Press to continue cooking in manual mode
(untimed) or press
by setting a new duration. In both cases, the cooking
parameters will be retained.
or .
to extend the cooking time
9. FAVORITES
Once cooking is complete the display will prompt you
to save the function in a number between 1 and 10 on
your list of favorites.
ADD FAVORITE?
If you would like to save a function as a favorite and
store the current settings for future use, press
otherwise, to ignore the request press
Once has been pressed, press the
to select the number position, then press
confirm.
Please note: If the memory is full or the number chosen
has already been taken, the oven will ask you to confirm
overwriting the previous function.
To call up the functions you have saved at a later time,
press : The display will show your list of favorite
functions.
1. CONVENTIONAL
Press or to select the function, confirm by
pressing , and then press
10. CLEANING FUNCTIONS
STEAM SELF CLEAN
Press to show "Steam Self Clean" on the display.
Steam Self Clean
Press to activate the function: the display will
prompt you to do all actions needed to obtain the
best cleaning results: Follow the indications and then
press when done. Once you have done all steps,
when required press
cycle.
Please note: It is reccommended to do not open the oven
door during the cleaning cycle to avoid a loss of water vapor
that could get an adverse effect on the final cleaning result.
An appropriate message will start flashing on the
display once the cycle has finished. Leave the oven to
cool and then wipe and dry the interior surfaces with
a cloth or sponge.
11. DRAIN
The drain function allows the water to be drained in
order to prevent stagnation in the boiler. This product
has been developed in order to automatically run
a drain cycle once cooking has been stopped/has
ended.
Approximately 30min after the stop/end of cooking,
the oven will automatically drain the system, moving
the residual water in the drawer (be careful not
to remove the drawer after cooking). Once done,
the drawer can be extracted and emptied. We
recommend emptying the drawer as soon as the drain
is completed.
.
or
to
to activate.
to activate the cleaning