Tyre Repair - Mini Mobility Set Gebrauchsanweisung

Tyre repair

Instructions on how to use the Mobility
Set can also be found on the compressor
A.
Remove the sticker (1) on the AIR/REPAIR rotary
switch (2) on the compressor A.
Move the AIR/REPAIR rotary switch (1) to
REPAIR.
Remove the twist-off cap on the hose (1) of the
compressor A and screw the hose (1) onto the
tyre valve (2). Ensure that the hose (1) is firmly
attached as otherwise the sealant may leak.
Connect the plug to the 12 V socket (3) inside
the car.
Place the remote control on the steering column
and switch on the ignition by touching the Start-
Stop button.
Do not touch the brake or clutch pedal
as this will start the engine. Remember
that the compressor and any other
consumers will subject the car's battery
to a significant load.
Switch on the compressor A. Inflate the tyre to
a minimum of 2.0 bar and a maximum of 2.5 bar
(the sealant will be pumped into the tyre at the
same time).
If the tyre pressure inside the tyre is higher than
required, press the button (4) to let air out of the
tyre.
17