Charging The Battery, Leds; Charging The Battery; Displaying State Of Charge; Leds On Battery - Stihl FSA 90 Gebrauchsanleitung

6 Charging the Battery, LEDs

6 Charging the Battery, LEDs
6.1

Charging the Battery

The charging time depends on several factors, e.g.
temperature of the battery or the ambient temperature. The
actual charging time may differ from the specified charging
time. For specified charging times see www.stihl.com/
charging-times.
► Recharge the battery fully as described in the instruction
manual for the STIHL AL 101, 300, 500 chargers.
6.2

Displaying State of Charge

1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds and indicate
the state of charge.
► If the LED on the right flashes green: Charge the battery.
6.3

LEDs on Battery

The LEDs can show the state of charge or malfunctions. The
LEDs can glow or flash green or red.
The state of charge is indicated when the LEDs glow or flash
green.
► If the LEDs glow or flash red: Troubleshooting, @ 19.
Malfunction in trimmer or battery.
0458-709-9621-A

7 Assembling the Trimmer

7.1
FSA 90
► Switch off the trimmer, push retaining latch to position
and remove the battery.
2
80-100%
60-80%
40-60%
20-40%
► Remove the wing screw (1).
0-20%
► Remove the upper clamp molding (2).
► Place the handlebar (3) in the lower clamp molding (4).
► Fit the upper clamp (2).
► Insert the wing screw (1).
► Swing the handlebar (3) up.
► Tighten down the wing screw (1).
► Take out the screw (6).
► Position the control handle (7) on the handlebar (3),
trigger facing the gearbox, and line up the hole in the
control handle with the hole in the handlebar.
► Fit the nut (7).
► Insert and tighten down the screw (6) firmly.

Mounting the Handle

1
3
4
5
English
8
7
6
3
51