Removing And Installing Metal Cutting; Attachment - Stihl FSA 90 Gebrauchsanleitung

English
► Fit the fanwheel (2) on the shaft (3) with fan blades facing
up.
► Fit the mowing head (1) on the shaft (3) and turn it
counterclockwise.
► Insert the stop pin (4) in the bore as far as stop and hold
it depressed.
► Rotate the mowing head (1) counterclockwise until the
stop pin (4) engages in position.
The shaft is now blocked.
► Tighten down the mowing head (1) firmly by hand.
► Remove the stop pin (4).
7.4.2 Removing the Mowing Head
► Switch off the trimmer, push retaining latch to position
and remove the battery.
► Insert the stop pin in the bore as far as stop and hold it
depressed.
► Rotate the mowing head (3) until the stop pin engages in
position.
The shaft is now blocked.
► Unscrew the mowing head clockwise.
► Remove the fanwheel.
► Remove stop pin.
7.5

Removing and Installing Metal Cutting

Attachment

7.5.1 Mounting Metal Cutting Attachment
► Switch off the trimmer, push retaining latch to position
and remove the battery.
54
1
2
3
4
5
6
7
► Fit the fanwheel (5) on the shaft (6) with fan blades facing
up.
► Place the cutting attachment (4) on the fanwheel (5). If
you are fitting a circular saw blade or a grass cutting blade
with more than 4 cutting edges: Its cutting edges must
face in the same direction as the arrow on the deflector.
► Place the thrust washer (3) on the metal cutting
attachment (4) so that its raised side faces up.
► Place the rider plate (2) on the thrust washer (3) so that its
closed side faces up.
► Insert the stop pin (7) in the bore as far as stop and hold
it depressed.
► Rotate the metal cutting attachment (4) clockwise until the
stop pin (7) engages in position.
The shaft (6) is now blocked.
► Fit the nut (1) counterclockwise and tighten it down firmly.
► Remove the stop pin (7).
7 Assembling the Trimmer
0458-709-9621-A