8 Adjusting Trimmer for User
7.5.2
Removing the Metal Cutting Attachment
► Switch off the trimmer, push retaining latch to position
and remove the battery.
► Insert the stop pin in the bore as far as stop and hold it
depressed.
► Rotate the metal cutting attachment clockwise until the
stop pin engages in position.
The shaft is now blocked.
► Unscrew the mounting nut clockwise.
► Remove the rider plate, thrust washer, metal cutting
attachment and fanwheel.
► Remove stop pin.
8 Adjusting Trimmer for User
8.1
Fitting and Adjusting the Carrying System
1
2
► Put on the shoulder strap (1) or full harness (3).
► Adjust the shoulder strap (1) or full harness (3) so that the
carabiner (2) is about a hand's width below your right hip.
8.2
Balancing the Trimmer
► Switch off the trimmer and push retaining latch to position
.
0458-709-9621-A
► Connect the carrying ring (1) to the carabiner (2).
3
► Let go of the trimmer and check to see how it is balanced
2
► If the trimmer cannot be balanced:
- the cutting attachment should just rest on the ground.
3
► Loosen the screw (3).
English
1
2
2
55