Charging The Trimmer, Leds; Charging The Trimmer; State Of Charge; Leds - Stihl FSA 45 Gebrauchsanleitung

English
► If 3 LEDs flash red while you are checking the controls:
Remove the activation key and contact your STIHL
servicing dealer.
There is a malfunction in the trimmer.
► If you cannot carry out this work: Do not use your trimmer
and contact your STIHL servicing dealer.

6 Charging the Trimmer, LEDs

6.1

Charging the Trimmer

The charging time depends on several factors, e.g.
temperature of the trimmer or ambient temperature. The
actual charging time may differ from the specified charging
time. For specified charging times see www.stihl.com/
charging-times.
The charging process starts automatically
when the plug is inserted in a wall outlet and
the charging cable is connected to the
trimmer. The charging process stops
automatically when the trimmer is fully
charged.
The trimmer and charging cable heat up during the charging
process.
► Remove the activation key.
1
2
► Insert the plug (5) in a convenient wall outlet (6).
► Lay the connecting cable (4).
40
6
5
3
4
► Insert the charger plug (3) in the charge socket (2).
The LEDs (1) glow green and show the state of charge.
► If the LEDs (1) stop glowing: Disconnect the charger plug
(3) from the charge socket (2).
The trimmer is fully charged.
► Disconnect the plug (5) from the wall outlet (6).
6.2

State of Charge

80-100%
60-80%
40-60%
20-40%
0-20%
► Press the button (1).
The LEDs (5) glow green for about 5 seconds and indicate
the state of charge.
► If the left LED flashes green: Recharge the trimmer.
6.3

LEDs

Indicate state of charge or malfunctions in the trimmer. The
LEDs can glow or flash green or red.
The state of charge is indicated when the LEDs glow or flash
green.
► If the LEDs glow or flash red: Troubleshooting, @ 18.
There is a malfunction in the trimmer.

7 Assembling the Trimmer

7.1

Mounting the Deflector

► Switch off the trimmer and remove the activation key.
6 Charging the Trimmer, LEDs
1
0458-718-9621-A