Gsm Cell Information - Conrad GX107 Bedienungsanleitung

Example:
The switching input was configured to trigger an alarm at HIGH. The idle countdown starts
when IN1 has reached the LOW condition. If the alarm condition if IN1 is reached again during
the IDLE time (HIGH), the countdown is reset but no alarm is triggered (idle time did not
elapse). Only when IN1 retained the LOW condition without interruption for at least the set IDLE
time will IN1 be able to trigger an alarm text message again.
This does not affect any other alarm like ADC or GPS.
Reason: This function protects the customer from immense text message costs.

13.2 GSM Cell Information

If the "GX107" does not have any GPS receiver or cannot find any site, you can have the current
GSM zone designation and a cell information sent to you at any time.
Use the following text message command for this:
TEST CELL #1513

To break down the radio cell codes, contact your mobile phone provider.
Observe that the query about the current site is not supported by all providers.
Example: Text message report
GX107 1.xx
- - - - - - - - -
Batt: 90%
GSM: 50%
Zone: 3F7A
Time: 1
Cell info:
Hirschau
Adjacent cells:
AD3E
25AD
84
Note: The map is taken from the OpenStreetMap project!