Safety Information - Conrad GX107 Bedienungsanleitung

5. Safety Information

The guarantee/warranty will expire if damage is incurred resulting from non-
compliance with the operating instructions! We do not assume any liability
for consequential damage!
We do not assume any liability for damage to property or personal injury
caused by improper use or the failure to observe the safety instructions! In
such cases the guarantee/warranty will expire!
• This module left the factory in perfect condition in terms of safety engineering. To
maintain this condition and to ensure safe operation, the user must observe the
safety information and warning notes in these operating instructions.
• This module is equipped with highly integrated components. Electronic
components are very sensitive to static electricity discharge. Only touch the
module by the edges and avoid contact with the pins of the components on the
circuit board.
• Unauthorised conversion and/or modification of the module switching is
inadmissible for safety and approval reasons (CE).
• When handling products that may come into contact with electric voltage,
observe the valid VDE regulations, especially VDE 0100, VDE 0550/0551,
VDE 0700, VDE 0711 and VDE 0860.
• Consult an expert if you are unsure as to the function, safety or connection of the
module.
• The module must only be operated after it has been installed in the casing
protected from touch. The power must be switched off when installing the module.
All wiring work must be performed with the power switched off.
• Direct contact of the circuit board with water must be avoided at all times.
• Do not operate the module in rooms or under unfavourable conditions where
combustible gases, vapours or dust are or may be present.
• Before taking the module into operation, always check it and its cables for
damage.
If you have reason to believe that the device can no longer be operated safely,
disconnect it immediately and make sure it is not unintentionally operated.
55