Call (Incall) - Conrad GX107 Bedienungsanleitung

12.4 Call (INCALL)

The "INCALL" function can be connected to any output ("OUT1"=relay, "OUT2"= transistor).
This function can be used in two modes:
Mode "Toggle": The output is switched at call
Mode "Time": Output is activated for an adjustable time

Only the phone numbers previously stored with the command SET TEL may use
this function.
Just call the "GX107" and let it ring a few times to be safe. Observe that the phone
number from which the "GX107" is called is not unknown (suppression of caller ID)
and was stored in the correct format in the "GX107". Otherwise, the "GX107" will
ignore the call and not switch any output.
INCALL setting:
SET INCALL <OUT1/OUT2> <activation time> #1513
Example:
SET INCALL OUT1 23 #1513
After this command, output1 will activate for 23 seconds if receiving a call.

The time can be set from 1 to 43200 seconds (12 hours).
If the time is set to "0" first, the "INCALL" is in mode "Toggle", i.e. if the "GX107" is
called for the first time, the output is activated; at the second time, it is deactivated,
etc.
Reset to factory settings
Send the following command to reset to factory settings (OUT1, time = 0):
RESET INCALL #1513
80