System Commands; Alarm Timer - Conrad GX107 Bedienungsanleitung

13. System Commands

With the following commands, you can change important protective functions of the "GX107".
If you have the default settings, you thereby accept the resulting changed behaviour of the
"GX107".

13.1 Alarm Timer

In case of alarm, the "GX107" will send an alarm message. Further messages of the same type
are only sent if the corresponding alarm situation was left for a specified period (factory
settings: 5 minutes). This period can be changed.
Use the following text message command:
SET IDLEALARM <Time> #1513
The time can be set between 1 and 240 minutes.
Example:
SET IDLEALARM 15 #1513
The period between alarm messages is now 15 minutes.
Attention!
During this period, you will not be informed that the reason for alarm has changed
again. Observe that you must check the parameter yourself during this period.
Reset to factory settings
Send the following command to reset to factory settings (5 minutes):
RESET IDLEALARM #1513
Checking settings
To verify the desired settings, use the command:
TEST IDLEALARM #1513
83