Dantherm RCV320 P1 Übersetzung Der Originalanleitung Seite 5

Introduction: Overview
Abbreviations in
this manual
The following abbreviations are used in this manual:
Abbreviation Description
T1 Outside air inlet into the unit
T2 Supply air from the unit into the dwelling
T3 Extract air from the dwelling into the unit
T4 Extract air from the unit
S1 Temperature sensor no 1
S2 Temperature sensor no 2
S3 Temperature sensor no 3
S4 Temperature sensor no 4
Operating mode Standard operating mode on delivery, connection diagram and further
A information see chapter Installation options
Operating mode Operating mode with inverted fan, connection diagram and further
B information see chapter Installation options
ISO Coarse 75 % Standard air filter according to ISO 16890; corresponds to G4 filter accor-
ding to EN779 (obsolete standard)
ePM1>50% Pollen filter according to ISO 16890 – absorbs finer particles than ISO
Coarse 75 %. Corresponds to F7 filter according to EN779 (obsolete
standard)
BP Bypass damper
(allows filtered fresh air to be blown into the dwelling, bypassing the
heat exchanger)
IP Unique address for Ethernet port
DHCP Automatic assignment of an Ethernet address provided from an external
network component (if unit is connected to Ethernet)
PC PC running MS Windows
USB Universal serial bus connection
LAN Local area network
WAN Wide area network
BMS Building Management System
PCB Printed Circuit Board
FFC Flat Flexible Cable
5