Dantherm RCV320 P1 Übersetzung Der Originalanleitung Seite 10

Demand-controlled
operation
10
Activate demand-controlled operation if you want to control the quality of the room air
automatically. In this mode, the measured values of the VOC, RH and/or CO2 sensors are used
to control the quality of the room air. Therefore, the respective sensors must be connected for
demand-controlled operation. The CO2 sensor can only be connected via an installed Acces-
sory Controller (HAC).
Pressing and holding (five seconds) the Week/Auto button activates demand-controlled ope-
ration. When demand-controlled operation is activated, this will be indicated by the corre-
sponding LED flashing slowly.
USER MANUAL
Operation: Overview