Dantherm RCV320 P1 Übersetzung Der Originalanleitung Seite 41

INSTALLATION AND SERVICE MANUAL FOR PROFESSIONALS
Installation: Assembly
4.
Fig. 42: Checking the alignment
Floor installation
The unit can transmit vibrations to the surrounding components in non-insulated floor con-
structions, e.g. in attics. For non-insulated floor constructions, the unit must be placed on a
sound-insulating substructure.
1.
Fig. 43: Creating a wooden substructure
2.
Ensure that the unit is horizontally aligned. The top edge of the unit must be in a hori-
zontal position or slightly inclined from the wall. Note: The top edge must not be inclined
towards the wall as this may cause moisture damages.
INFORMATION
Create a wooden substructure with an insulation of at least 50 mm thickness for noninsu-
lated floor constructions. Ensure that the substructure is aligned horizontally. Note: Make
sure that the substructure can support the weight of the unit.
750 mm
Fit the Dantherm-approved floor brackets (accessories) to the unit to establish the re-
quired distance from the unit to the floor. Information: Dantherm accepts no liability for
floor brackets from other manufacturers. Using other floor mounts is at your own risk.
850 mm
100 mm
41