Dantherm RCV320 P1 Übersetzung Der Originalanleitung Seite 44

44
5. Route the condensate drain hose in a way that a siphon is created that is at least 100 mm
high. The siphon can be created in two ways:
A) directly under the unit (suitable for most wall installations) or alternatively
B) at the end of the drain hose (suitable for floor installations)
B
Fig. 49: Creating a siphon
6. Fill the siphon with at least 0.5 l of water.
7. When routing the siphon directly under the unit, use the hose clamp supplied. To do so,
fix the hose clamp in the opening on the underside of the unit and guide the condensate
drain hose through the hose clamp to create a siphon.
Fig. 50: Using the hose clamp
8. Guide the hose to a drain and make sure it is not exposed to frost. Install a heating cable
around the drain hose if the insulation is not sufficient to provide a frostproof drain hose.
9. Ensure a minimum inclination of 1 % (1 cm/metre).
INSTALLATION AND SERVICE MANUAL FOR PROFESSIONALS
Installation: Assembly
A