Troubleshooting - Spengler Neotens Nomad Neo100 Gebrauchsanweisung

Troubleshooting

Anomaly Possible cause
The wrist cuff is too tight or
too loose, or the strap wrist is
poorly attached
Arm/wrist or device move-
ment during measurement of
blood pressure
Blood
pressure Talking, being nervous or
monitor emotional during measure-
working ment
abnormally
Incorrect measurement
posture
There is interference in
the loading process or an
incorrect operation in the
measurement process.
The following table shows the error messages that may occur during the measure-
ment, possible causes and treatment methods. Please measure again using the correct
method.
When an error or warning occurs, the error code is displayed on the screen and the
cuff icon flashes.
The type of code is a warning: one beep is emitted, short press the "
return to the stable state.
The type of code is an error: emits 4 continuous beeps. Displays the error 3 secondes,
then automatically powers off.
MANUEL UTILISATEUR NEOTENS NOMAD | WWW.SPENGLER.FR
Solution
Roll the cuff correctly
Stay quiet, keep your arm/wrist
steady and do not move the
monitor.
Avoid speaking, breathe deeply to
calm down and try to relax.
Adjust your posture.
See operating instructions.
" button to
EN
67