Operation Instructions - Holzmann MTY 8-70 Originalbetriebsanleitung

11.1

Operation instructions

The machine is specially designed for hard alloy grinding blade, which is fit for grinding all

kinds of hard alloy saw blades.
Its fascia can support the teeth of saw blade and other parts in order to prevent jumping

and improve grinding quality.
The positioning pin can be adjusted to the best position in order to ensure the conforma-

bility of grinding blade.
Slip board can rotate horizontally, which can ensure the primary grinding angle or change

it.
The rotation table on the fascia can adjust the process angle of grinding blade.

 If the center axle is far away from the direction of grinding blade, and when the diameter
of grinding saw blade and saw teeth are bigger, the angle of saw blade is smaller, the
grinding blade and saw blade can be reversed 180
gle.
Slip block, centre axle, limited screw is installed on the rotation table, which is fit for oper-

ation and ensure the diameter from grinding blade to the center.
20 rotation structure is installed on the grinding head, which can meet grinding for bevel

saw teeth.
The diamond wheel can be dry-grinded.

First loose the fascia, then adjust the angle of grinding blade and fasten.

 Adjustment of center axle
 Rotate the center axle to the grinding blade when grinding small saw; otherwise away
from the grinding blade.
Push the center axle to the right

Install the saw blade, rotate the wheel and decide the position of grinding surface of saw

teeth.
Rotate the rotation table to ensure the angle if grinding face of saw teeth.

Rotate the rotation table in order to ensure process angle of grinding blade .The cross an-

gle between the grinding surface and work.
HOLZMANN Maschinen Austria  www.holzmann-maschinen.at
and adjust the table to a proper an-
Adjustment of positioning assembly.

Adjust the saw blade to the best
grinding condition, rotate the posi-
tioning frame and fascia, adjust posi-
tioning pin to the more proper base of
saw teeth and leave gap of grinding
quantity, the fasten the fixed screw.
Adjust the center axle to the same

gap of grinding quantity to the right.
After all the parts are fastened, the

saw blade supported with hand will be
grinded.
Kreissägeblattschärfmaschine/ circular saw blade grinder MTY 8-70
OPERATION
Seite 18