GB
CAUTION. pressure washers
can be dangerous if they are
not operated correctly! The
jet must never be directed
at people, animals, electric
equipment con-nected to the
power supply or against the
actual pressure washer..
•
Do not direct the jet at yourself or others
in order to clean clothes and shoes.
•
Never point the waterjet at electrical
equipment. Risk of electric shock!
•
Never use the device as a source of
drinking water.
•
When cleaning sensitive or painted
surfaces (e.g. a car), only use the
weight of the brush as contact pressure
to prevent damage to the surface. If in
doubt, test a concealed area first.
•
Clean the brush head before each use.
Foreign bodies inside the brush can
damage the surface being cleaned.
•
Do not operate the pressure washer
when other people are in the immedi-
ate vicinity, other
wearing protective clothes.
•
Do not trigger the high-pressure jet until
the pressure jet brush is in contact with
the surface to be cleaned.
•
Take appropriate measures to keep chil-
dren away from the equipment whilst it
is running.
•
Dispose of the packaging material cor-
rectly.
•
Do not use the equipment in the vicinity
of flammable liquids or gases. Non-
observance will result in a risk of fire or
explosion.
•
Store the equipment in a dry place and
out of reach of children.
•
Children should be supervised to en-
sure that they do not play with the ap-
pliance.
•
Observe the safety instructions of the
high-pressure cleaner.
6
than they are also
Caution! To avoid damage to
the equipment and any pos-
sible person injury resulting
from this:
•
Do not work with damaged or incom-
plete equipment, or with equipment
that has been converted without the ap-
proval of the manufacturer.
•
Protect the device from frost.
•
Use only original accessories and do
not carry out conversion work on the
equipment.
Fitting
•
To connect to the pressure wash-
er, snap the bayonet mount into
the pressure washer's jet gun.
•
Screw the retainer nut (1) against
the spray gun.
Alternative connection with
adapter
To connect
-
Fit the adapter (3) onto the
extension element (2) or the con-
nection pipe of the PARKSIDE
accessory and turn through 90°
until it clicks into place (Bayonet
catch). Screw the nut (1) to the
adapter (3).
-
Connect the pressure washer jet
gun (Bayonet catch) and tighten
the retainer nut (4) on the adapt-
er (3).
To release
-
Release the retainer nut of adapter
(4) on the adapter (3).
-
Loosen retainer nut (1) on the
pressure jet brush.
-
Release the catches by pushing
and turning through 90° in the op-
posite direction (Bayonet catch).