Risk Of Injury - Dimplex La 4060Cp Montage- Und Betriebsanleitung

English
DANGER
Risk of death due to fire and explosion
Flammable refrigerant may leak if the heat pump falls or is subject to impact load during transportation.
▪ Protect the device against mechanical damage during transportation.
▪ Avoid setting down the device heavily.
▪ If outflow noises can be heard, if oily surfaces form or if a leakage can be detected with a detector, the refrigerant
must be drained off by a person trained in handling of propane.
▪ Avoid ignition sources in the surrounding area until safe drainage has been completed and set up a safety zone of
5 m around the heat pump. If the leakage occurs inside a building, the affected area must be ventilated
immediately.
▪ The heat pump must be returned to the manufacturer for repair if it not possible to remedy the leakage on site. To
this end, remove the propane refrigerant correctly, fill the refrigerating circuit with nitrogen and document this with
a note on the device.
DANGER
Risk of lightning
During thunderstorms, do not stand in the immediate vicinity of the heat pump.
WARNING
Risk of injury due to tipping
▪ Secure the heat pump to prevent tipping.
▪ When transporting on a pallet, observe the centre of gravity.
WARNING

Risk of injury

Working on the device without protective equipment can result in injuries such as cuts.
▪ Wear personal protective equipment consisting of safety gloves, safety shoes, safety glasses and long-sleeved
clothing that fully covers the body.
Only transport the device to the final installation location in its original transport packaging. The basic device can be
transported with a lift truck or a crane.
!
When transporting the heat pump, ensure that it is not tilted by more than 45° (in any direction).
!
Transportation, including all related activities such as lifting, loading, lowering, unloading and unpacking, must be
carried out by trained personnel.
!
Only use suitable transport equipment. Observe the load capacity of the load suspension device.
1. The transport routes must be cleared and suitable agents must be spread if necessary (for defrosting or deadening)
2. Where possible, transport the device to the final installation location on a pallet.
3. Transport the basic device with a lift truck or crane.
!
CAUTION! Observe off-centre centre of gravity! If the crane hook is positioned centrally, the device will be
out of balance when lifting.
EN 12
•
452173.66.03c FD 0509
•
LA 4060CP
www.dimplex.eu