Lubricating The Chain; Mounting The Saw Head On The Telescopic Handle; Sharpening The Saw Chain - Parkside Pahe 20-Li E5 Originalbetriebsanleitung

♦ Place the saw chain
Ensure that
running in the correct direction (see Fig.
♦ Attach the blade
facing upwards and guide the saw chain
The guide rail
blade guide
♦
♦
♦ Now, tighten the saw chain
tion
♦
Tightening and checking
WARNING!
► Wear protective gloves! There is a
danger of injury from the sharp cutting
teeth!
♦
♦ Turn the chain tensioning ring
sion.
♦ The saw chain
the saw chain
blade by hand.
♦
pletely.
NOTE
► A new saw chain
must be tightened more regularly.

Lubricating the chain

♦
♦
with
|
GB / MT
on the blade
the saw chain is
with the labelling
.
must be above the
on.
slightly.
(see sec-
completely.
.
in a
must lie against the
can be drawn over the
com-
stretches and
.
.
.
WARNING!
►
If the saw chain
ting equipment may become irrepa-
rably damaged within a short time.
oil level
NOTE
► Use only saw chain oil. Preferably
biodegradable. Do not use waste oil,
motor oil, etc.
►
Mounting the saw head on the
telescopic handle
♦
on the upper end of the telescopic han-
-
♦
turning it towards the
♦ For removal, turn the red connecting
piece towards the
1a
the saw head
dle 1.
NOTE
►
sharpening in the sharpening set.
► Alternatively, you can use an electri-
cal saw chain sharpening device and
follow the instructions of the manufac-
turer.
► If you have any doubts about imple-
should be replaced.
runs dry, the cut-
13a
symbol on the
.
13a
symbol and pull
13a
13a
can be
-
by
1a
-