Initial Use; Checking The Automatic Oil System; Adjusting The Telescopic Handle; Adjusting The Handle - Parkside Pahe 20-Li E5 Originalbetriebsanleitung

Initial use

NOTE
► Comply with regulations regarding
noise protection and local rules. Using
the appliance on certain days (e.g. on
certain times (midday period, night
or prohibited.
♦
switch .
♦ After the starting process, the safety
can be released.
♦ Release the ON/OFF switch

Checking the automatic oil system

the oil level and the automatic oil system.
♦ Switch the appliance on and hold it over
pliance must not touch the ground.
♦ If there is an oil trace, the appliance is
opera ting correctly.
♦ If there is no oil trace, clean the oil dis-
penser or have the appliance repaired
by our Customer Service.
♦ To clean, wipe the residues from the oil
dispenser using a brush or cloth.

Adjusting the telescopic handle

The telescopic handle
.
♦
adjust the length by pushing or pulling
as required.
.
-
can be adjusted
and
♦
the telescopic handle
♦

Adjusting the handle

♦ Undo the screw on the handle
the handle can be moved.
♦ Set the handle
♦ Retighten the screw on the handle

Adjusting the cutting angle

NOTE
► The cutting angle can be adjusted in 3
stages.
♦ Remove the
pliance.
♦ Press the release button
♦ Adjust the angle of the motor unit to the
required position.
♦ Let go of the release button
♦
appliance.
WARNING!
► Pay attention to falling clippings.
► Be aware of the danger of branches
NOTE
► Place the stop
quietly.
► Now you can begin with the sawing.
►
remove cut branches from treetops
and shrubs.
again, there-
.
has
until
3a
in the desired position.
3a
from the ap-
.
and the
on the branch. This
lets you easily
15a
|
GB / MT
.