Checking The Battery Charge Level; Charging The Battery; Operation; Working Instructions - Parkside Performance Pwsap 20-Li F6 Originalbetriebsanleitung

Checking the battery charge level

LEDs
red, orange, green
red, orange
red
At the battery
1. Press the button (21) next to the charge
level indicator button (20) on the battery
(22).
The LEDs of the charge level indicator
show how much charge remains in the
battery.
2. Charge the battery (22) when only the red
LED on the charge level indicator (20) is
illuminated.
At the tool
1. The charge level indicator (11) lights up
during operation. If the charge level indic-
ator does not light up, press the Unlock
button (13).
The LEDs of the charge level indicator
show how much charge remains in the
battery.
2. Charge the battery (22) when only the red
LED on the charge level indicator (11) is
illuminated.

Charging the battery

See also the charger instruction manual.
Notes
• If warm, allow the battery to cool before
charging.
• Do not expose the battery to direct sun-
light for long periods and do not place it
on a radiator (max. 50°C).
Procedure
1. If necessary, remove the battery (22) from
the cordless device.
2. Slide the battery (22) into the charging
slot (24) of the charger (23).
3. Plug the charger (23) into an power out-
let.
4. Once charging is complete, disconnect
the charger (23) from the mains supply.
5. Pull the battery (22) charging slot out
(24).
Meaning
Battery charged
Battery partially
charged
Battery needs to be
charged
Control LEDs on the charger (23)
green red
lights up —
— lights up
— flashes
flashes flashes

Operation

Working instructions

• WARNING! Risk of injury! If pos-
sible, use clamps to hold the workpiece
in place. Never hold a small workpiece
in one hand and the device in the other
while using the device.
• DANGER! Risk of injury! Ensure that
you have sufficient space in which to
work, and that you do not endanger other
people.
• Adjust the guard cover such that any
sparks or detached parts cannot hit either
the user or any bystanders.
The guard cover must also be positioned
such that the sparks cannot ignite com-
bustible parts, including those in the sur-
roundings.
• The power tool must not be used with a
cutting stand.
• Only switch on the device when the at-
tachment tool is not touching the work-
piece.
• Excessive pressure reduces the perform-
ance of the power tool and leads to faster
wear of the attachment tool.
• Always work in the counter-direction. This
ensures that the device is not pushed out
of the cut through lack of control.
The direction of rotation arrow (7) symbol-
ises the running direction of the attach-
ment tool.
• After a heavy load, let the device idle for a
few minutes to cool down the attachment
tool.
• Do not touch the attachment tool until it
has cooled down.
GB
MT
Meaning
• Battery is fully
charged
• stand-by (No bat-
tery inserted)
Battery is charging
Battery is overheated
Battery is defective
37