Inserting/Removing The Battery Pack; Checking The Battery Pack's Charging Level; Assembly - Parkside Performance Passp 12-Li A1 Bedienungsanleitung

NOTE
Let the charger
u 9 ] [
15 minutes between successive charging
processes.
Before operation: Charge the battery
o
pack when it is at medium or low
5 ] [
charging level (see "Checking the battery
pack's charging level").
The charging control LEDs (red
o
green ) indicate the status of the
[ ]
charger and the battery pack
9 ] [
LED
Red LED lights up
[ ]
Green LED lights
[ ]
up
Green LED and
[ ]
red LED flashing
[ ]
Red LED flashing
[ ]
Green LED lights
[ ]
up (without battery
pack )
[ 5 ]
1. Insert the battery pack
charger .
9 ] [
2. Connect the mains plug of the charger
to a mains outlet.
3. When the battery pack
– Disconnect the mains plug of the
charger from the mains outlet.
[ 9 ]
– Remove the battery pack
charger .
9 ] [
˜ Inserting/removing the
battery pack
Inserting the battery pack
1. Push the battery pack
handle .
3 ] [
2. Ensure the battery pack
in place.
30 GB/IE
cool down for at least
and
[ ]
.
[ 5 ]
Status
Battery pack
5 ] [
charges
Battery pack fully
[ 5 ]
charged
Battery pack
5 ] [
defective
Battery pack too
5 ] [
cold or too warm
Charger ready
9 ] [
into the
[ 5 ]
9 ] [
is fully charged:
[ 5 ]
from the
5 ] [
into the
[ 5 ]
clicks audibly
[ 5 ]
Removing the battery pack
1. Press the release button
pack .
5 ] [
2. Pull the battery pack
handle .
3 ] [
˜ Checking the battery pack's
charging level
The charging level LEDs
o
charging level after the product is switched
on and off:
Colour
Red/orange/green
Red/orange
Red
˜ Assembly
˜ Fitting/removing the dust
box
(Fig. C, E)
WARNING! Risk of injury!
m
Always switch the product off,
remove the battery pack
let the product cool down before
making any adjustments.
NOTE
The adapter for dust box
u
installed on the dust box
When working vertical surfaces: The dust
u
box has to face downwards.
2 ] [
For optimum dust extraction: Empty the
u
dust box regularly.
2 ] [
Optional: The dust can be extracted with
u
a vacuum cleaner (e.g. PWD 30 C1).
Fitting the dust box
1. Fit the adapter for dust box
extraction outlet
[
2. Align on the adapter for dust box
[ ]
with on the dust box
on the battery
[ 4 ]
from the
[ 5 ]
display the
[ 6 ]
Charging level
Maximum
Medium
Low
and
[ 5 ]
is pre-
[ 1 ]
.
2 ] [
onto the
1 ] [
.
]
1 ] [
.
[ 2 ]