Control Display; Shifting Gears - Rcb Rk15 Originalbetriebsanleitung

Motor
The motor provides you with power when you pedal. You can set the required speed level
via the display. The maximum assisted speed of an electric motor is 25 km/h.
Battery
The electric assist transmission requires a battery for energy support. The battery is located
under the frame. The battery can be charged by removing it from the frame using a suitable
spanner.
Only use the supplied charger to charge the battery. The battery is equipped with the following
connections and indicators:
- Charging socket
- Switch button
- Lock for locking the battery
Lithium-ion batteries are classified as dangerous goods
according to transport regulations. If the battery is installed in a bicycle, transport by water and
road is permitted. (Please check your local transport regulations). Defective batteries must not
be transported and must be disposed of properly!

Control Display

The control display is installed on the handlebars. The maximum effective speed for the speed
display function is 25 km/h. Higher speeds cannot be displayed. Do not set the display
parameters yourself. If the parameters are set incorrectly, the electronics may malfunction,
making the bicycle unusable. In this case, please contact the manufacturer.

Shifting Gears

Your bicycle is equipped with a derailleur. Selecting the correct gears is a prerequisite for a
relaxed ride and for the proper functioning of the power assist system. The derailleur gear
consists of the following components:
-The sprocket box on the rear wheel
-Rear derailleur
-Single chainring for single crank
-Transmission chain
-Shift lever
Use the plus button to increase your cadence. Use the minus button to decrease your
cadence. You cannot change the assistance level when shifting manually. When shifting gears,
remove the load from the pedals and pedal lightly. Otherwise, serious damage to the entire
drive system can occur!
Deutsch / English / Français / Español / Italiano / Nederlands / Polski
(65)