RCB RK15 Originalbetriebsanleitung Seite 62

4
4. Fasten the top cover screw plug.
6. Put the handlebar into the riser and adjust the
handlebar angle in the middle. Close the front
cover.
Note: Do not twist the wiring harness.
Take out the 10mm socket
Combine the 16-in-1 tools as shown in the diagram
Deutsch /
6
+
English / Français / Español / Italiano / Nederlands / Polski
5. Use the No. 4 Allen wrench from the 16 in
1 tool to remove the four front cover screws
and remove the front cover of the riser.
7. Use the No. 4 Allen wrench from the
16 in 1 tool gradually tighten the four
front cover screws in the order shown in
the figure.
(59)
5
7
3
1
4
2