Table of contents
1
Introduction ........................................................
2
3
4
Proper use..........................................................
5
6
7
Unpacking ..........................................................
8
Assembly............................................................
9
10 Operation ...........................................................
Explanation of the symbols on the
product
Symbols are used in this manual to draw your attention to
potential hazards. The safety symbols and the accompa-
nying explanations must be fully understood. The warn-
ings themselves will not rectify a hazard and cannot re-
place proper accident prevention measures.
Before commissioning, read and observe
the operating manual and safety instruc-
tions!
Attention! Failure to observe the safety signs
and warning information affixed to the prod-
uct and failure to observe the safety and op-
erating manual can result in serious injury or
even death.
Wear safety goggles.
Wear hearing protection. Excessive noise
can result in a loss of hearing.
Always wear a safety helmet!
Wear protective gloves.
Wear sturdy footwear!
26
26
26
27
27
28
29
30
31
32
34
34
36
37
37
38
39
56
+
www.scheppach.com
Keep your feet away from the tool attach-
ment.
Keep hands and feet away from the rotating
parts of the tool.
Maintain the safety distance! Caution! Eject-
ed parts.
Danger of poisoning! Only use the product
outdoors and never in closed or poorly venti-
lated rooms.
The motor becomes very hot during opera-
tion, do not touch!
Naked flames or smoking near the device is
strictly prohibited!
Do not use a saw blade.
Material removal direction
Danger due to ejected foreign objects
Make sure that other persons maintain a
sufficient safety distance.
Thread coil diameter.
Cutting blade diameter.
Mixing ratio of fuel to 2-stroke engine oil
40:1
Oil tank contents.
Tank contents
Press the fuel pump "primer" 10x.
Choke open/closed
GB | 25